Analog: Manual Test (Signaling)
CMD 80 Digital Radiocommunication Tester User Manual
3–63
You can also press the CONFIG front-panel button to display a configuration
menu that is dependent on the state of the call sequence. See Figure 3–40.
Figure 3–40: Analog manual test configuration — MS registered menu displayed by
CONFIG front-panel key
Press the STANDBY POWER softkey to display the STANDBY POWER
CONFIGURATION menu. Refer to Figure 3–38 on page 3–61.
You use the STANDBY POWER CONFIGURATION menu to set the maximum
limit of the standby power as measured in the MS UNREGISTERED and MS
REGISTERED menus shown in Figure 3–33 on page 3–54 and Figure 3–39 on
page 3–61, respectively. You can also toggle the auto stop function on or off and
set the parameters to their default values. Refer to STANDBY POWER on
page 3–120 for a detailed description of this menu.
Press the BS SIGNAL CONFIG softkey to display the MS UNREGISTERED
OR REGISTERED menu for the base station signal configuration. See Fig-
ure 3–34 on page 3–56.
Press the PAGING DURATION softkey to set the paging duration. The paging
duration is how long the base station sends a paging message over the control
channel to the mobile station when a call is being established. If you set this time
too short, the signal search algorithm of the mobile station may take longer than
the paging duration, and the call setup will fail.
When you press a CALL TO MOBILE softkey and establish a call, the tester
displays either a CALL ESTABLISHED (VOICE LOOPBACK) menu or a
CALL ESTABLISHED (MS TESTS) menu, depending on which CALL TO
MOBILE softkey you pressed. Each of these menus is discussed in the
following text.
Call Established
Summary of Contents for CMD 80
