Tektronix CMD 80, User Manual, Page: 497 / 672

Appendix F: Remote Control Command Tables
CMD 80 Digital Radiocommunication Tester User Manual
F–61
Table F–9: CDMA module test commands (cont.)
Command Notes State Values
CONFigure:CMTest:LIMit:ERRor:POWer:MSTation <error limit [DB]> 0.0 dB to
3.5 dB to
10.0 dB ALL
4
CONFigure:CMTest:LIMit:ERRor:POWer:MSTation? ALL
CONFigure:CMTest:LIMit:ERRor:TTIMe <maximum transmit time error> [S | SEC | MS | US] 0.0
m
s to
1.0
m
s to
10.0
m
s
ALL
4
CONFigure:CMTest:LIMit:ERRor:TTIMe? ALL
CONFigure:CMTest:LIMit:IMBalance[:UPPer] <maximum carrier imbalance [DB]> –120.0 dB to
–30.0 dB to
–20.0 dB ALL
4
CONFigure:CMTest:LIMit:IMBalance[:UPPer]? ALL
CONFigure:CMTest:LIMit:WQUality[:LOWer] <minimum waveform quality> 0.000 to
0.944 to 1.000 ALL
5
CONFigure:CMTest:LIMit:WQUality[:LOWer]? ALL
CONFigure:CMTest:OCNS[:STATe] <OFF | ON> ALL
CONFigure:CMTest:OCNS[:STATe]? OFF, ON ALL
CONFigure:CMTest:PCBits:MODE <OFF | HOLD | ADOWn | AUP | RTESt> IDLE, CMT
6
CONFigure:CMTest:PCBits:MODE? OFF, HOLD,
ADOWn, AUP,
RTESt ALL
CONFigure:CMTest:PNOFfset <PN offset value> 0 to 511 IDLE, CMT
7
CONFigure:CMTest:PNOFfset? ALL
CONFigure:CMTest:POWer:MSTation:MANual <power level> [DBM] –88.0 dBm to
0.0 dBm to
31.0 dBm CMT
8
CONFigure:CMTest:POWer:MSTation:MANual? MAX, MIN CMT
CONFigure:CMTest:POWer:MSTation:MODE <MANual | OLOop> CMT
9
5
Use this command to set the error limit for the measurement. The displayed value (in LOCAL control) goes to reverse
video when the error limit is exceeded.
6
Use this command to select how the power control bits in the forward CDMA traffic channel are calculated. The OFF
mode disables the insertion of power control bits. The HOLD mode sends alternating up/down power control bits. The
ALL DOWN mode forces the power control bit to the down state. The ALL UP mode forces the power control bit to the up
state. The RANGE TEST mode sends eight frames of UP power bits followed by eight frames of DOWN power bits.
7
Use this command to set the PN offset of the tester. This command immediately changes the sync channel timing and
content, and the paging channel content and long code mask. Changes are performed without any handoff.
8
Use this command to set the expected power from the mobile station when you are using
CONFigure:CMTest:POWer:MSTation:MODE in the MANual mode.
9
Use this command to set the method for determining the expected power from the mobile station. The MANual mode
requires that the user enter the expected value; the OLOop mode estimates the open loop power using the network type
and the NOMINAL BS TOTAL POWER setting.