Tektronix CMD 80, User Manual, Page: 653 / 672

Appendix I: Autorun
CMD 80 Digital Radiocommunication Tester User Manual
I–13
The sequence test allows you to configure a user defined test sequence. You
activate or deactivate a single test by toggling the softkey next to it in the
SELECT SEQUENCE (CONFIGURE TEST SEQUENCE menu).
After choosing individual tests, you can also save the sequence setting with the
save/recall option.
The Sequence Test allows you to select transmitter and receiver tests. Therefore,
access to the transmitter and receiver configuration menus is provided.
In the SELECT SEQUENCE (CONFIGURE TEST SEQUENCE) menu are two
softkeys for setting the test parameters:
H
CONFIG TXD: Config menu described in the TXD Test (CDMA) section
of this appendix, page I–9.
H
CONFIG RXD: Config menu described in the RXD Test (CDMA) section
of this appendix, page I–11.
The menus accessible via the CONFIG TXD and CONFIG RXD softkeys are
identical to those shown on pages I–10 and I–12, respectively. Because of this,
any change in one menu will cause the same change in the other menu display.
Figure I–15: Autorun select sequence (configure test sequence) menu
To leave this config menu press the MENU UP key next to the spin wheel.
To start the Sequence Test, press the START softkey. During the test, the current
state of the test is progressively displayed.
After the Sequence Test is finished, the test results are displayed at once.
Press the MENU UP key to leave the Test Results menu. The Printer Menu is
then automatically displayed (see Printer Menu on page I–8).
Autorun sequence test
(CDMA)