Tektronix CMD 80, User Manual, Page: 76 / 672

CDMA: Manual Test (Signaling)
CMD 80 Digital Radiocommunication Tester User Manual
3–11
with the VAR control. Establishes the maximum number of access probes
transmitted in a single sequence.
Range: 1 to 16
H
SEQUENCES PER ATTEMPT. Press this softkey to use the VAR control to
set the number of access probe sequences per access attempt
(“MAX_REQ_SEQ” or “MAX_RSP_SEQ” of the Access Parameters
Message). Establishes the maximum number of access probe sequences
transmitted for either an access channel request or access channel response.
Range: 1 to 15
H
DEFAULTS. Press this softkey to return all access probe parameters to their
factory default values.
After the mobile station is powered on and registered, the tester enters the MS
Registered (idle/access) state. Figure 3–7 shows the display during this state.
Figure 3–7: MS registered menu (idle/access state)
The tester displays the mobile station information on the left side of the screen
and the base station information on the right side. You can use either of the two
CALL TO MOBILE softkeys to initiate a call to the mobile station, or you can
place a voice loopback call from the mobile station by entering any telephone
number on the mobile station and pressing SEND.
MS Registered