Tektronix CMD 80, User Manual, Page: 74 / 672

CDMA: Manual Test (Signaling)
CMD 80 Digital Radiocommunication Tester User Manual
3–9
H
CALL TO MOBILE. Activation of the upper softkey causes the tester to
initiate a voice loopback call to the mobile station. Pressing the lower
softkey initiates the mobile station loopback tests (Service Option 2 as
specified in IS-126).
CDMA MANUAL TEST MS Unregistered Configuration Menu. While in the MS
Unregistered (initialization) state, you can press the front-panel CONFIG key to
access the configuration menu (see figure 3–5).
Figure 3–5: CDMA manual test configuration menu (unregistered state)
This configuration menu gives you access to the configuration menus for the
following modes:
H
STANDBY POWER. This softkey displays the standby power configuration
menu, where you can set the maximum limit of standby power and toggle
the auto stop function on or off, or set the parameters to their default values.
H
ACCESS PROBES. This softkey displays the access probes configuration
menu, where you can define the nominal offset, initial offset, probe
increment, number of probes per sequence, and the number of sequences per
attempt. See figure 3–6.
H
MULTIPLE PILOTS. This softkey displays the multiple pilots configuration
menus, where you can define the PN offsets, pilot levels, T_ADD, and
T_DROP for multiple pilot tests. See figures 3–23 and 3–24, on page 3–39.
H
SOFTER HANDOFF. This softkey displays the softer handoff configuration
menu, where you can define the parameters for softer handoff. These
include: fer interval, maximum FER %, T_ADD and T_DROP levels, total
power, and the secondary sector PN offset and traffic channel. See figure
3–25 on page 3–40.