Tektronix CMD 80, User Manual

Page: 103 / 672

CDMA: Manual Test (Signaling)
3–38
CMD 80 Digital Radiocommunication Tester User Manual
H
RECEIVER QUALITY. Press this softkey to access the Receiver Quality
configuration menu (see figure 3–17).
H
TRANSMITTER QUALITY. Press this softkey to access the Transmitter
Quality configuration menu.
H
MULTIPLE PILOTS. Press this softkey to access the multiple pilots
configuration menu (see figures 3–23 and 3–24).
H
SOFTER HANDOFF. Press this softkey to access the softer handoff
configuration menu (see figure 3–25)
H
BS SIGNAL CONFIG. Press this softkey to access the base station signal
configuration menu (see the menu description on page 3–49).
H
POWER CNTRL BITS. Press this softkey to toggle the power control bits
between AUTO and HOLD. The power control bits will be reset to AUTO at
each call.
H
DATA RATE. Press this softkey to enable the front-panel VAR knob. Use the
VAR knob to select between data rates of FULL, HALF, QUARTER, and
EIGHTH. The data rate will be reset to FULL at each call.
H
TX QUALITY AVG COUNT. Press this softkey to use the front-panel VAR
knob to set the number of readings to be averaged together for TX Quality
values. This average is used to obtain the displayed Carrier Frequency Error,
Transmit Time Error, and Waveform Quality values in the Call Established –
MS Tests menu.
H
DEFAULTS. Press this softkey to return all selections to factory default
values.
Multiple Pilots Configuration Menu. From the Call Established configuration
menu, press the multiple pilots softkey to display the multiple pilots configura-
tion menus (see Figures 3–23 and 3–24).