Taylor-Dunn B 1-50, Operation, T Roubleshooting And Replacement Parts Manual

Page: 22 / 240

SAFETY RULES AND OPERATING INSTRUCTIONS
Safety Rules
Page 8
Battery Status Indicator, Digital Bargraph
The battery status indicator is located to the left of the hour meter. The
battery status indicator has a LED bar graph that indicates the relative
state of charge of the battery. The top LED will light only when connected
to a fully charged battery or after completing a charging cycle. Successive
lower LED’s will light as the battery charge diminishes. When the second
from the bottom LED flashes the battery energy status is in energy reserve
and should be placed on charge as soon as possible. When the two bottom
LED’s are alternately flashing the batteries are empty and the truck should
be taken out of service and charged to avoid damaging the batteries.
Reverse or Motion Alarm (Optional)
The reverse alarm is located in the electronics compartment mounted on
the speed control panel or on the rear panel of the vehicle. The reverse
alarm is activated when the Key switch is in the “ON” position and the
Forward-Reverse switch is in the reverse position. The alarm makes a
repeated audible sound.
Electrolyte Alarm (Optional)
The Electrolyte Alarm is located in the battery area, in the 4th battery cell
from the main battery positive cable. The Electrolyte alarm is activated
when the battery cell fluid level falls below the level of the probe. The
alarm is an audible continuous sound along with a bi-color indicator lamp.
Inspect the fluid level in all battery cells when the alarm sounds or the bi-
color lamp turns from its green color to red. The vehicle batteries should
then be filled and/or charged. With the fluid level at a normal operating
level and/or the batteries charged the alarm and light will reset.
Directional Signals (Optional)
The turn signal lever is located on the left side of the steering column.
Push the lever forward to activate the right turn signal and pull the lever
back to activate the left turn signal.