Page 28
CAUTION: Unplug the vacuum cleaner before servicing
8. Use a screwdriver to pry open the base connector (Fig. I.) Remove the harness from the base
connector.
9. Remove the handle harness by pulling it out through the grip end of the handle (Fig. J.)
10. Run new harness through the tube. Insert it into the base connector as shown in figure K. Close the
connector and insert it into the tube. Make sure the connector is postioned as shown in Fig. L.
Continued on next page
II. Maintenance and Repairs
P. Replacing the Handle Harness (Continued)
Fig. I
Fig. J
Fig. K
Fig. L
