A
Appendices
Specifications
A-5
Single Sequence Advance
Current segment is sampled the specified number
of repetitions and then idles at the end of the
segment. Next trigger samples the next segment
the specified repeat count, and so on.
Mixed Sequence Advance
Each step of a sequence can be programmed to
advance either a) automatically (Automatic
Sequence Advance), or b) with a trigger (Stepped
Sequence Advance)
Sequencer Steps
1 to 4096
Segment Loops
1 to 1Meg
Minimum Segment Duration
600 ns
Minimum Segment Size in a Sequence
16 points
Multi Sequence
1 to 10, selectable
Custom Sequence Creation Software
ArbConnection software allows instrument control
and creation of custom sequences. Sequences are
built as tables and downloaded to the instrument
Modulated Waveforms Generator Characteristics
General
Description
Using this mode of operation, one may select from a
list of built-in modulation schemes.
Carrier Waveform (CW)
Sinewave
Modulation Source
Internal
Run Modes
Off (outputs CW), Continuous, Triggered, Delayed Trigger, Re-trigger, Burst and
Gated
Interrupted Modulation Carrier Idle Mode
On or Off, programmable
Run Mode Advance Source
Front panel TRIG IN, Software commands
Trigger Delay
(Trigger input to modulation output)
[(0; 200 ns to 20 s) + system delay]
Resolution
20 ns
Error
6 sample clock 150 ns + 5% of setting
Re-trigger Delay
(Modulation end to modulation restart)
200 ns to 20 s
Resolution
20 ns
Error
3 sample clock 20 ns + 5% of setting
Trigger Parameters
All trigger parameters such as level, slope, jitter, etc.
apply
Marker Output
Description
Marks the crossing of a specific frequency and step
setting. The marker pulse is generated through the
SYNC connector. Marker placement is available for
all modulation modes except AM
Level
TTL into open circuit
Marker Type
Single pulse at the specified frequency
Position
Programmable for a specific frequency setting
Sweep
Swept Waveform
Sine wave
Sweep Step
Linear or log
Sweep Direction
Up or Down
Sweep Range
10 Hz to 100 MHz
Sweep Time
1.4
s to 40 s
FM
Modulated Waveform
Sine wave
Modulating Waveforms
Sine, square, triangle, Ramp
Carrier Frequency Range
10 Hz to 100 MHz
Summary of Contents for 5251
