Suzuki Engine 2002 GRAND VITARA SQ625, Service Manual

Page: 781 / 834

6G-6 CRANKING SYSTEM (0.9 kW, 1.2 kW and 1.4 kW Reduction Type)
Unit Repair Overhaul
Dismounting and Remounting
Use following procedure to remove starter :
1) Disconnect negative battery lead at battery.
2) Disconnect magnetic switch lead wire and battery cable from
starting motor terminals.
3) Remove two starting motor mount bolts.
4) Remove starting motor.
5) To install, reverse the above procedure.
Disassembly
1) Remove protector (if equipped) and magnetic switch.
NOTE:
• Before disassembling starting motor, be sure to put
match marks at two locations (A & B) as shown in fig-
ure left so that any possible mistake can be avoided.
• Do not clamp yoke in a vise or strike it with a hammer
during repair operations.
1. Magnetic switch
2. Front housing
3. Yoke
1. Magnetic switch
2. Protector
NOTE:
Don’t disassemble this switch. If defective, replace as a
complete assembly.
1. Magnetic switch
2. Spring
3. Plunger