Suzuki Engine 2002 GRAND VITARA SQ625, Service Manual

Page: 466 / 834

ENGINE MECHANICAL (H25 ENGINE) 6A2-91
8) Install 1st timing chain.
Refer to “1st Timing Chain and Chain Tensioner” in this sec-
tion for installation.
9) Install LH bank 2nd timing chain.
Refer to “LH (No.1) Bank 2nd Timing Chain and Chain Ten-
sioner” in this section for installation.
10) Install timing chain cover.
Refer to “Timing Chain Cover” in this section for installation.
11) Install oil pan and pump strainer.
Refer to “Oil Pan and Oil Pump Strainer” in this section for
installation.
12) Install cylinder head cover.
Refer to “Cylinder Head Cover” in this section for installation.
13) Install exhaust manifold.
Refer to “Exhaust Manifold” in this section for installation.
14) Install radiator outlet pipe, radiator, cooling fan and water
hose.
Refer to “Cooling Water Pipes or Hoses”, “Radiator” and
“Cooling Fan and Fan Clutch” in Section 6B for installation.
15) Install throttle body and intake manifold.
Refer to “Throttle Body and Intake Manifold” in this section
for installation.
16) Adjust water pump drive belt tension.
Refer to “Cooling Fan Belt Tension Check and Adjustment” in
Section 6B for adjusting procedure.
17) Adjust power steering pump drive belt tension.
Refer to “Power Steering Driver Belt” in Section 3B1 for
adjusting procedure.
18) Adjust accelerator cable play and A/T throttle cable play.
Refer to “Accelerator Cable Adjustment” and “A/T Throttle
Cable Adjustment” in Section 6E2.
19) Check to ensure that all removed parts are back in place.
Reinstall any necessary parts which have not been rein-
stalled.
20) Refill engine with engine oil, referring to “Engine Oil and Fil-
ter Change” in Section 0B.
21) Refill cooling system referring to “Cooling System Flush and
Refill” in Section 6B.
22) Refill front differential housing with gear oil if drained, refer-
ring to “Maintenance Service” in Section 7E.
23) Connect negative cable at battery.
24) Check ignition timing and adjust as necessary, referring to
“Ignition Timing Check and Adjustment” in Section 6F2.
25) Verify that there is no fuel leakage, water leakage, oil leak-
age and exhaust gas leakage at each connection.
26) Check wheel alignment, referring to “Front End Alignment” in
Section 3A.