Suzuki EN125-2A, Service Manual

Page: 59 / 208

3-27 ENGINE
CAMSHAFT
Align the mark on magneto rotor with the index
mark on the crankcase keeping the camshaft
drive chain pulled upward.
CAUTION:
If crankshaft is turned without drawing the
camshaft drive chain upward. the chain will
be caught between crankcase and cam chain
drive sprocket.
Align the marks on the camshaft so it is parallel
with the surface of the cylinder head.
Fit lock washer so that it is covering the locating
pin.
Apply THREAD LOCK SUPER "1303B" to the
bolts and tighten the cam sprocket.
NOTE:
Apply grease on the cam sprocket locating
pin and install the pin into the camshaft.
Engage the chain on the cam sprocket with the
locating pin hole at just past top position.
NOTE:
Do not rotate magneto rotor while doing this.
When the sprocket is not positioned
correctly, turn the sprocket. When installing
the camshaft into the cam sprocket, pay
attention not to dislodge the locating pin or it
may fall into the crankcase.
Tightening torque
10 13 N m
(1.0 1.3 kg m)
THREAD LOCK SUPER
"1303B"
99000-32030