Suzuki EN125-2A, Service Manual

Page: 23 / 208

PERIODIC MAINTENANCE AND TUNE-UP PROCEDURES 2-10
Loosen the lock nut and screw the adjuster
on the clutch lever holder all the way in.
Loosen clutch cable adjuster lock nut .
Turn the clutch cable adjuster in or out to
acquire the specified play.
Tighten lock nut while holding the adjuster in
CARBURETOR
Inspect initial 1 000 km and Every 4 000 km
THROTTLE CABLE PLAY
There should be 0.5-1.0 mm play on the throttle
cable .To adjust the throttle cable play.
Clutch play should be 4 mm as measured at the
clutch lever holder before the clutch begins to
disengage. If the play in the clutch is incorrect,
adjust it in the following way:
CLUTCH
Inspect initial 1 000 km and Every 4 000 km
IDLING ADJUSTMENT
NOTE:
Make this adjustment when the engine is hot.
Start up the engine and set its speed at
anywhere between 1 300 and 1 500 r/min by
turning throttle stop screw .
Engine idle speed
1400 100r/min
A
Tug on the throttle cable to check the amount of
play.
Loosen the two lock nuts and turn the adjuster
in or out until the specified play is obtained.
Secure the lock nuts while holding the adjuster
0.5 1.0 mm
-
The clutch cable should be lubricated with a light
weight oil whenever it is adjusted.
1
A
4
3
3
1
2
4mm
Throttle cable play
A
2