3-13
ENGINE
CAMSHAFT CAM WEAR
Worn-down cams are often the cause of mistimed
valve operation resulting in reduced output power.
The limit of cam wear is specified for both intake
and exhaust cams in terms of cam height
,
which is to be measured with a micrometer.
Replace camshafts if found it worn down to the
limit.
Micrometer
(25 50 mm)
09900-20202
H
Cam height
service limit
Intake cam
33.350 mm
Exhaust cam
33.000 mm
Height
H
Measure the outside diameter of camshaft journal.
Replace either the cylinder head set or the cam
shaft if the O.D. is incorrect.
Micrometer
(0 25 mm)
09900-20205
Camshaft journal
O.D.standard
21.959 21.980 mm
CAMSHAFT RUNOUT
Measure the runout with a dial gauge. Replace the
camshaft if the runout exceeds the limit.
09900-20701
09900-20606
09900-21304
Magnetic stand
Dial gauge (1/100 mm)
V-block (100 mm)
Service limit
0.10 mm
CAMSHAFT JOURNAL WEAR
Summary of Contents for EN125-2A
