Suzuki EN125-2A, Service Manual

Page: 187 / 208

1-5
FRONT WHEEL AXLE
Check with a dial indicator to see if there is any run-out
in front axle. In case of excessive run-out, front axle
should be replaced.
Dial gauge (1/100) 09900-20606
Magnetic dial gauge rack
V-block (100mm)
09900-20701
09900-21304
Service limit 0.25mm
WHEEL RIM
Note:
The run-out of wheel rim inspected with the
method described in the right-side figure
should not exceed service limit. Excessive
run-out results from excessive wear or
loosening of wheel bearing. Replacement of
bearing reduces run-out.
In case of failure in reducing run-out by
replacing bearing, adjust spoke tension. In
case adjustment of spoke tension fails in
reducing run-out, replace wheel rim.
Service limit
(axial and radial)
2.0mm
SPOKE NIPPLE
Inspect and confirm that all spoke nipples are fastened.
If necessary, fastened them with special tools.
Tightening torque
4 5N.m
0.4 0.5kg.m
Spoke nipple spanner
09940-60113
TIRE
Adequate tire tread depth ensures effective braking
and stable riding. Replace tire in case tread depth
reaches wear limit as shown in the right side figure.
Tire service limit 1.6mm
FRONT WHEEL AND FRONT BRAKE