Sun Microsystems Netra X4200 M2, Service Manual

Page: 81 / 222

Chapter 3 Maintaining the Netra X4200 M2 Server 67
FIGURE 3-45
Removing the GRASP Board From the Motherboard
5. Raise the corner of the GRASP board until it is clear of the locking tab. See
Procedure 2 in
FIGURE 3-45
.
6. Pivot the front edge of the GRASP board upward to disengage it from the rear
plastic bracket and to disengage its connector from the motherboard. See
Procedure 3 in
FIGURE 3-45
.
Note – Gently lift to avoid bending the GRASP board while removing or installing.
Installing the GRASP Board
To install the GRASP board, reverse the steps you used to remove the GRASP board.
Push firmly on the center of the board to avoid bowing and ensure full mating of the
motherboard connector.
Power status
LED CR1