Sun Microsystems Netra X4200 M2, Service Manual

Page: 60 / 222

46 Netra X4200 M2 Server Service Manual • May 2007
6. Consider your next steps:
■
If you are replacing the hard drive, continue to “Installing a Hard Drive” on
page 46 .
■
If you are not replacing the hard drive, perform administrative tasks to
configure the server to operate without the hard drive.
Installing a Hard Drive
1. Remove the replacement hard drive from its packaging and place the drive on
an antistatic mat.
2. Align the replacement drive to the drive slot.
The hard drive is physically addressed according to the slot in which it is
installed. See
FIGURE 3-21
. It is important to install a replacement drive in the
same slot as the drive that was removed.
3. Slide the drive into the bay until it is fully seated (
FIGURE 3-21
).
FIGURE 3-21
Installing the Hard Drive Into the Server
4. Close the latch to lock the drive in place.
5. Close the front bezel (
FIGURE 3-22
).