Sturtevant Richmont Global 400mp, User Manual

Page: 52 / 73

Global 400mp User Manual 52 of 72 v4.0
Chapter 5: Atlas Copco Open Protocol 17 August 2016
This setting controls how many times the Global 400mp will resend a subscription notification
packet, such as MID 0015 or MID 0061, to the client. If no response is received within the
specified ack timeout, the Global 400mp will try again, up to the specified number of retries. If
no response is received after all retries, the ACOP connection is considered broken and will have
to be re-established. This will terminate all subscriptions that were established on that
connection, regardless of which one did not receive a response.
Transmit Rejects
Default: yes
This setting determines if reject tightenings are sent to the Open Protocol network. If set to yes,
all tightenings will be sent to the network. If set to no, only accepts will be sent to the network,
both cycles and batch completes. This setting does not affect if rejects are logged to the unit
storage and has no effect if the Global 400mp NOKs setting is not set to Report or Count.
Port
Range: 0 to 65535
Default: 4545
This setting controls the network port on which the unit listens for Open Protocol connections to
interface 1. The network port used for interfaces 2-4 will be the following three ports. For
example, the default setup listens for interface 1 connections on port 4545, interface 2
connections on port 4546, interface 3 connections on port 4547, and interface 4 connections on
port 4548. If this setting were changed to 5000, the Global 400mp would listen for interface 1
connections on port 5000, interface 2 connections on port 5001, interface 3 connections on port
5002, and interface 4 connections on port 5003.
Cell ID
Range: 0 to 9999
Default: 0
This setting controls the value put in the Cell ID field of Open Protocol commands such as MID
0001 and 0061.
The same Cell ID will be used for connections on all interfaces.
Channel ID
Range: 0 to 99
Default: 0
This setting controls the value put in the Channel ID field of Open Protocol commands such as
MID 0001 and 0061.
The same Channel ID will be used for connections on all interfaces.
Enable OP Control
Default: yes