Sturtevant Richmont Global 400mp, User Manual, Page: 18 / 73

Global 400mp User Manual 18 of 72 v4.0
Chapter 1: Overview 17 August 2016
2. No function
3. REFRESH – Refresh the graph with the data for the most recent run of the tool.
4. RETURN [ESC] – Returns to the Unit Status Screen.
The Rundown Graph screen retrieves and shows the last rundown from the active air tool in the
selected interface. If no air tool is active for the selected interface, no graph will be retrieved.
The rundown will be overlaid with yellow horizontal lines for each of the three thresholds and
vertical lines showing the timers, purple for Timer Min and Timer Max, blue for Timer Clutch.
Additionally, the total time for the rundown is shown at the right end of the horizontal axis.
Network Status
Figure 6: Network Status screen
The network status screen shows the current Ethernet status
of the unit. The MAC address is assigned by the factory
and cannot be changed. The IP address, subnet mask, and
gateway may be edited from the Network Setup - General
screen or assigned via DHCP.
The Ethernet 1 and 2 lines indicate if a physical cable
connection is detected on the corresponding Ethernet ports
of the unit. If no connection on a port is detected, the unit
will show “Not connected”. If a connection is detected, the
baud rate and duplex of the connection will be listed.
The rest of the screen shows some basic information about the active Ethernet connections. For
each connection, this page shows the source address, time of the last packet on the connection,
which interface the connection is to, and some protocol specific information, such as last MID
received or which EtherNet/IP
TM
connection points are being used.