Sturtevant Richmont Global 400mp, User Manual

Page: 39 / 73

Global 400mp User Manual 39 of 72 v4.0
Chapter 3: Configuring the unit 17 August 2016
This setting determines if the Global 400mp requires a VIN to be entered before tools will be
allowed to run. When set to yes, the Global 400mp will be automatically suspended an interface
whenever there is no currently entered VIN for that interface. When set to no, the Global 400mp
will not check the VIN before allowing tools to run.
A VIN may be entered through either the barcode scanner or a network command. The VIN may
be cleared by a network command, an external input, or the
Clear VIN on batch setting. If the
VIN is cleared while an operation is running and this setting is set to yes, the Global 400mp will
immediately suspend that interface until a new VIN is entered for the interface. There is only
one copy of this setting for the entire Global 400mp, but each interface has its own VIN and is
suspended and resumed separately when this setting is enabled.
Clear VIN on batch
Default: no
This setting determines if the Global 400mp automatically clears the VIN when a batch
completes. When set to no, the Global 400mp will never automatically clear the VIN. The VIN
may still be cleared by other means, such as a network command or external input.
When set to yes, the Global 400mp will clear the VIN for an interface when an operation
completes on the interface, regardless of if the operation is set to repeat. When directly running
a parameter, the VIN will be cleared when a batch is completed. When running a job, the VIN
will be cleared when the last step in the job is completed.
NOKs
Default: Report
Values: Ignore, Display, Report, Count
This setting determines how the unit will handle NOK results (or rejects). The following table
summarizes the behavior for the different levels:
Level Beep
1
Show on
Screen
Store in
Flash
Report to
Network Overall bad
2
Increment
Count
Ignore No No No No No No
Display Yes Yes No No No No
Report Yes Yes Yes Yes No No
Count Yes Yes Yes Yes Yes Yes
1. Unit will only beep if Beep on reject is set to yes and Volume is not 0.
2. Overall bad will be indicated by showing yellow instead of blue or green in the parameter
area when the parameter batch is completed.
All results from tools that are not currently running are logged in the event log but otherwise
ignored, regardless of this setting.
Radio transmits
Default: 3
This setting controls how many times a tool radio will attempt to send a result before giving up.
In general, this setting does not have to be changed, but if tool communication is not working
reliably, changing this setting may improve communication.