Chapter 7 - Configuring Network Attached Storage
Configure NAS Services
3.
Select
Action > Configure Replication
. The Configure Replication dialog box displays.
Figure 147
The Configure Replication dialog box.
4.
Select the
Enabled
check box. The options below are unavailable and not configurable
until this check box is selected.
5.
Select the
Replication Target
from the drop-down menu. The targets are listed by the IP
address or hostname entered in
. If you only configured the system to
replicate to a single target, the target is preselected.
6.
Enter the name of the storage pool on the target you want to use for replication in the
Destination Pool Name
. This field is case sensitive.
7.
Enter the name of a volume that resides on the target storage pool you selected in
in the
Destination Volume Name
field, or enter the name for a new volume to be created
on the specified storage pool. This field is not case sensitive.
CAUTION
You cannot use this volume for normal data storage operations, it can only be
used as a replication target. Any data in the specified target volume is deleted
each time the system replicates data to the target.
• If the volume does not exist on the target, it is created.
• If the volume exists on the target, a warning message displays informing you that any
data currently in the target volume is erased each time data is replicated. Confirm the
warning message to continue.
November 2020
User Guide-BlackPearl Converged Storage System
- 240 -
