Rev. F
dated 02/07/2015
SVP08-0/1/2/3 - Code: 3529.0231.01
50
Service
Phone (+39) 0445.595.111
PT
0715
MV
0715
MC
0715
Arc. 66-VII
7.4.1.2 Replacing the drive belt (ref. 2 Fig. 14 on page 55)
1) Remove the guards;
2) set the machine to its minimum speed of production, using the handwheel
(
ref. 5
Fig. 4
on page 23);
3) turn off the machine, while moving the general switch to the 0 position (
ref. 1
Fig. 10
on page 39);
4) disconnect the plug from the electrical connector;
5) remove the chain (
ref. 9
Fig. 14
);
6) using one hand, grip the belt which is stretched between the two pulleys (
ref. 4
and
7
Fig. 14
);
7) using the other hand, turn the handwheel (
ref. 5
Fig. 4
) until the belt can be
extracted;
8) fit the new belt by first forcing it into the groove of the variable pulley (
ref. 7
Fig. 14
) so that it is stretched as taut as possible;
9) setting the handwheel (
ref. 5
Fig. 4
) to minimum production speed;
10) fit it around the driven pulley (
ref. 4
Fig. 14
);
11) refit the chain (
ref. 9
Fig. 14
);
12) refit the side guards, securing them using the respective fixing screws.
7.4.1.3 Replacing the outfeed conveyor drive belt (ref. 6 Fig. 14)
1) Remove the side guards;
2) Raise the motor base (
ref. 8
Fig. 14
) until the belt can be extracted from the
pulley groove;
3) keeping the base raised, fit the new belt;
4) refit the side guards, securing them with the relative fixing screws.
7.4.1.4 Replacing the outfeed conveyor belt (ref. 3 Fig. 4)
1) Remove the side guards;
2) slacken the conveyor belt as much as possible;
3) remove the plastic guard from the conveyor frame inside the machine outfeed
opening;
4) through the holes of the pulley (
ref. 3
Fig. 14
), remove the locking screws of the
cap located behind it;
5) remove the Seeger ring which secures the shaft (
ref. 5
Fig. 14
);
6) remove the two fixing screws of the conveyor belt support sheet from the back
of the machine;
7) gently pull the conveyor assembly towards the outfeed so as to free the support
sheet from the necks of the roller;
8) pull the pulley towards you (
ref. 4
Fig. 14
), after having tapped on the neck of
the roller with a metal prop (
ref. 5
Fig. 14
), and fully extract the roller;
9) fully extract the conveyor belt assembly;
10) replace the conveyor belt;
11) reinsert the entire assembly until it is possible to fit the roller which was
previously extracted from the conveyor belt;
12) refit the Seeger ring;
Warning!
Once the belt is removed, the motor will be unsupported. Do not let the
base drop suddenly, but hold it in position or lower it gently downwards
using your hand.
Summary of Contents for SVP08-0
Page 2: ......
