SVP08-0/1/2/3 - Code: 3529.0231.01
Rev. F
dated 02/07/2015
Arc. 66-V
PT
0715
MV
0715
MC
0715
Service
Phone (+39) 0445.595.111
31
5.
Preparation for use
5.1
Assembly
The machine, which is supplied with a standard hopper (ø 640 mm), is pre-
assembled in the Manufacturer’s factory.
For machines with an extended hopper (optional), assemble as follows:
1) using the silicon sealant supplied with the machine, apply an even bead of
sealant to the hopper support plate;
2) position the hopper on the plate, making sure to align the holes of the plate with
those of the hopper;
3) fasten the hopper with the 4 screws supplied;
4) raise the upper guard (
ref. 1 Fig. 4
on page 23);
5) connect the hopper cable to the connector which is attached to the machine
frame;
6) close the upper guard (
ref. 1 Fig. 4
).
5.2
Subsequent disassembly
If the machine must be disassembled for any reason, carry out the steps described
in paragraph
“5.1 Assembly” on page 31
, points 1) to 6), in reverse order.
5.3
Mounting:
Not applicable to the machine.
5.4
Installation
5.4.1
Hooking up to the line:
Refer to the line Manual.
Qualified
Technician
The operations described below must only be carried out by a qualified
technician.
Qualified
Technician
The operations described below must only be carried out by a qualified
technician.
Summary of Contents for SVP08-0
Page 2: ......
