Sony LMT-300, User Manual

Page: 29 / 71

22
Content
C
h
ap
te
r 1
U
s
e
r Gu
id
e
Validate process is suspended during presentation and
resumes when presentation is completed.
Rename DCP
Allows you to change the DCP Name. A DCP may or may
not be “named” during the creation of the distribution
package. If a name has been included in the distribution the
name may not be one that is easily recognized by the user.
The feature allows you to Rename the DCP for easier
reference.
Note: If a DCP is renamed and then subsequently ingested
again the assigned name will be lost and the DCP name
will revert to the name assigned (if any) when the
distribution package was created.
To rename an existing DCP, tap Menu , tap Content , and
then tap Manage DCPs . The MANAGE DCPs pane
appears. Tap either the Scroll Up or Scroll Down
arrow until you locate the DCP of interest, tap the DCP to
select, and then tap Rename. An on-screen keyboard
appears. Using the keyboard, enter the new DCP Name
and then tap
ENTER.
Ingest DCPs
A Digital Cinema Package (DCP) must be ingested into
the Media Block’s RAID storage system. This process
occurs under control of the Media Block.
To Ingest one or more
DCPs, tap
Menu , tap
Content and then tap
Ingest DCP . The
INGEST DCP pane
appears.
The DCP Ingest feature
includes the ability to
start more than one DCP
ingest process. While the
majority of DCP
operations will normally
take place using the SMS
Controller, similar
features have been added
to allow operators to perform DCP Ingest tasks when the
need arises.
To assist the operator in the ingest process, a USB
connector (Ingest Port) has been located on the Lamp
Breaker Panel as shown in the illustration.
Located to the right of the RS-232
connector is a USB connector
labelled Ingest Port. You can plug a
USB 2.0 Drive into this connector
and it will appear as a folder in the
Ingest DCP list.
The only function available on the INGEST DCP pane is
Ingest (shown in the illustration below).
Because a DCP is a container for a number of files, the
DCP appears as a folder in the DCP Ingest list. The target
DCP is found in one of the folders which have been
defined using the SMS Controller based on fixed locations
where storage/transfer media can be attached to the system
or network. To located the target DCP, tap
Scroll Up
or Scroll Down until you find the desired top level
folder and then tap the folder view its contents. Again,
Scroll Up or Scroll Down to locate the target DCP, tap to
select and then tap
Ingest . The DCP Ingest job is placed at
the end of the Ingest queue for processing. If you have
more than one DCP to ingest, locate the next DCP, select
and then tap
Ingest .
1
If you wish to cancel an ingest job, you must use the
functions found under
“DCP Ingest Status” on page 20 .
Tap Menu , tap Content and then tap DCP Ingest Status .
Note: The folder hierarchy on the transfer media may be
more than one level deep. Continue to navigate folders
until the target DCP has been located.
Ingest KDMs
The DCP associated Key Delivery Message (KDM) must
be ingested into the Media Block’s storage system. This
process occurs under control of the Media Block.
Tap Ingest DCP
Content Menu
Ingest
Port
1.Content Playback and DCP Ingest cannot occur at the
same time. Once a Ingest job is queued, the Media Block
will manage the Ingest process automatically. For addi-
tional options on DCP Ingest job management, see
“Man-
age DCPs” on page 21
Selected DCP
Ingest