Solartron Mobrey 3595 4C, User Manual

Page: 107 / 128

3595 4C User Manual Part Two IMP Commands
35952350 (CH01/AA)
1-55
Use FR command to set the
integration time. Use UN command
to set temperature units.
Use AM or TE command to set the
temperature reference for
thermocouples.
Use FR command to set the
sample rate on each channel.
Use CH TI command to set time-
out period on each channel.
This procedure may be omitted if
only default values are to be used.
IMP SPECIFIC
SET-UP
ANALOGUE MEASUREMENT IMP
IMP TYPES 3595 1A, 3595 1C
IMP TYPES 3595 2A ONLY
next channel
next channel
STRAIN GAUGE
SET-UP
Use CH GA command to set the
gauge factor for each channel.
Use CH OF command to reload
initial strain gauge offset data
from the Host PC.
Use IN command to initialise
strain gauge and store initial
data to Host PC.
next channel
This procedure must be
used to enable strain
gauge measurements.
Applies only to IMP
type 3595 1B only.
Figure 1.6: IMP Specific Set-up and Strain Gauge Set-up