Sokkia SRX1, Operator'S Manual, Page: 72 / 184

13. ANGLE MEASUREMENT
64
The SRX automatically turns from the reference direction to the specified angle (target).
• SRX also turns to the target coordinates when reference angle is omitted.

• Rotation may not be completed correctly when specifiying an angle near the zenith or nadir if "Tilt
crn." or "Coll. crn" is set to "Yes" in "Obs.condition".
PROCEDURE
1. Sight the point you will use as the reference angle
and set it as the reference angle.
Sight the reference point and press
[0SET] , or
input the reference point angle.

"13.1 Measuring the Horizontal Angle
between Two Points (Horizontal Angle 0°)"/
"13.2 Setting the Horizontal Angle to a
Required Value (Horizontal Angle Hold)"
2. Press {SETTINGS} to switch to SETTINGS
mode.
13.3 Turning the Instrument from the Reference Angle to a
Specified Angle