Sokkia SRX1, Operator'S Manual, Page: 143 / 184

135
22.WARNING AND ERROR MESSAGES
The following is a list of the error messages displayed by the SRX and the meaning of each message.
If the same error message is repeated or if any message not shown below appears, the instrument
has malfunctioned. Contact your Sokkia agent.
Backup battery dead. Clock display may no longer be correct.
The voltage supplied by the lithium battery either declines or is completely discharged. Ask your
Sokkia agent to replace the battery for you.
Bad condition
The air is shimmering a lot, etc., measuring conditions are poor.
The center of the target cannot be sighted.
Resight the target.
Unsuitable distance measurement conditions when reflectorless measurement is set. When
reflectorless measurement is set, distance cannot be measured because the laser beam is
striking at least two surfaces at the same time.
Choose a single surface target for distance measurement.

Precautions for setting prism: ""11. TARGET SIGHTING""
Calculation error
During resection measurement the same point is registered multiple times. Set another known
point so that the known point coordinates do not coincide.
During surface area calculation, conditions necessary for calculations are not met. Check
conditions and try again.
Cannot changing TS <==> SDR!!
Cannot switch to Program mode (SDR).
Perform a warm boot then power ON as normal. If this error message appears frequently, contact
your Sokkia agent.
Device list is full !!
No more Bluetooth devices can currently be registered. Delete unnecessary devices from the list
and try again.
Error: Read Build Info.
Error: Read sysflg
Error: Self check
Press [OK] to cancel the message. If this error message appears frequently, contact your Sokkia
agent.
Incorrect password.
Input password does not match set password. Input correct password.
Input device name !!
Bluetooth device name not input. Input device name and complete device registration.
Input over 3 letters !