C
OMMAND
L
INE
I
NTERFACE
4-201
mac-address-table static
This command maps a static address to a destination port in a VLAN. Use
the
no
form to remove an address.
Syntax
mac-address-table static
mac-address
interface
interface
vlan
vlan-id
[
action
]
no mac-address-table static
mac-address
vlan
vlan-id
•
mac-address
- MAC address.
•
interface
-
ethernet
unit
/
port
-
unit
- This is device 1.
-
port
- Port number.
-
port-channel
channel-id
(Range: 1-6)
•
vlan-id
- VLAN ID (Range: 1-4094)
•
action
-
delete-on-reset
- Assignment lasts until the switch is reset.
-
permanent
- Assignment is permanent.
Default Setting
No static addresses are defined. The default mode is
permanent
.
Command Mode
Global Configuration
Command Usage
The static address for a host device can be assigned to a specific port
within a specific VLAN. Use this command to add static addresses to
the MAC Address Table. Static addresses have the following
characteristics:
• Static addresses will not be removed from the address table when a
given interface link is down.
• Static addresses are bound to the assigned interface and will not be
moved. When a static address is seen on another interface, the address
will be ignored and will not be written to the address table.
• A static address cannot be learned on another port until the address is
removed with the
no
form of this command.
Summary of Contents for 8648T - annexe 1
