I
NTERFACE
C
OMMANDS
4-170
Command Usage
• To force operation to the speed and duplex mode specified in a
speed-duplex
command, use the
no negotiation
command to
disable auto-negotiation on the selected interface.
• When using the
negotiation
command to enable auto-negotiation,
the optimal settings will be determined by the
capabilities
command.
To set the speed/duplex mode under auto-negotiation, the required
mode must be specified in the capabilities list for an interface.
Example
The following example configures port 5 to 100 Mbps, half-duplex
operation.
Related Commands
negotiation (4 -170)
capabilities (4 -172)
negotiation
This command enables autonegotiation for a given interface. Use the
no
form to disable autonegotiation.
Syntax
[
no
]
negotiation
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#interface ethernet 1/5
Console(config-if)#speed-duplex 100half
Console(config-if)#no negotiation
Console(config-if)#
Summary of Contents for 8648T - annexe 1
