![background image](http://html1.mh-extra.com/html/smc-networks/8648t-annexe-1/8648t-annexe-1_management-manual_1300704037.webp)
C
ONNECTING
TO
THE
S
WITCH
2-3
To connect a terminal to the console port, complete the following steps:
1. Connect the console cable to the serial port on a terminal, or a PC
running terminal emulation software, and tighten the captive retaining
screws on the DB-9 connector.
2. Connect the other end of the cable to the RS-232 serial port on the
switch.
3. Make sure the terminal emulation software is set as follows:
•
Select the appropriate serial port (COM port 1 or COM port 2).
•
Set to any of these baud rates: 9600, 19200, 38400, 57600, 115200
(Note: Set to 9600 baud to view all system initialization messages.)
•
Set the data format to 8 data bits, 1 stop bit, and no parity.
•
Set flow control to none.
•
Set the emulation mode to VT100.
•
With HyperTerminal, select Terminal keys, not Windows keys.
Notes: 1.
When using HyperTerminal with Microsoft
®
Windows
®
2000,
make sure that you have Windows 2000 Service Pack 2 or later
installed. Windows 2000 Service Pack 2 fixes the problem of
arrow keys not functioning in HyperTerminal’s VT100
emulation. See www.microsoft.com for information on
Windows 2000 service packs.
2.
Refer to “Line Commands” on page 4-14 for a complete
description of console configuration options.
3.
Once you have set up the terminal correctly, the console login
screen will be displayed.
For a description of how to use the CLI, see “Using the Command Line
Interface” on page 4-1. For a list of all the CLI commands and detailed
information on using the CLI, refer to “Command Groups” on page 4-12.
Summary of Contents for 8648T - annexe 1
