C
OMMAND
L
INE
I
NTERFACE
4-108
dot1x operation-mode
This command allows single or multiple hosts (clients) to connect to an
802.1X-authorized port. Use the
no
form with no keywords to restore the
default to single host. Use the
no
form with the
multi-host max-count
keywords to restore the default maximum count.
Syntax
dot1x operation-mode
{
single-host
|
multi-host
[
max-count
count
]}
no dot1x operation-mode
[
multi-host max-count
]
•
single-host
– Allows only a single host to connect to this port.
•
multi-host
– Allows multiple host to connect to this port.
•
max-count
– Keyword for the maximum number of hosts.
•
count
– The maximum number of hosts that can connect to a port.
(Range: 1-20; Default: 5)
Default
Single-host
Command Mode
Interface Configuration
Example
dot1x re-authenticate
This command forces re-authentication on all ports or a specific interface.
Syntax
dot1x re-authenticate
[
interface
]
interface
ethernet
unit
/
port
-
unit
- This is device 1.
-
port
- Port number.
Console(config)#interface eth 1/2
Console(config-if)#dot1x operation-mode multi-host max-count 10
Console(config-if)#
Summary of Contents for 8648T - annexe 1
