VLAN C
OMMANDS
3-101
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• If ingress filtering is enabled, incoming frames for VLANs which do
not include this ingress port in their member set will be discarded at
the ingress port.
• Ingress filtering does not affect VLAN independent BPDU frames,
such as GVRP or STP. However, they do affect VLAN dependent
BPDU frames, such as GMRP.
Example
The following example shows how to set the interface to port 1 and
then enable ingress filtering:
switchport native vlan
Use this command to configure the PVID (i.e., default VID) for a port.
Use the
no
form to restore the default.
Syntax
switchport native vlan
vlan-id
no switchport native vlan
vlan-id
- Default VLAN ID for a port. (Range: 1-4094, no leading
zeroes)
Default Setting
VLAN 1
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#interface ethernet 1/1
Console(config-if)#switchport ingress-filtering
Console(config-if)#
Summary of Contents for 7500A/VCP - annexe 1
