SMC Networks 7500A/VCP - annexe 1, Management Manual

Page: 236 / 316

C
OMMAND
L
INE
I
NTERFACE
3-100
switchport acceptable-frame-types
Use this command to configure the acceptable frame types for a port. Use
the
no form to restore the default.
Syntax
switchport acceptable-frame-types { all | tagged }
no switchport acceptable-frame-types
• all - The port passes all frames, tagged or untagged.
• tagged - The port only passes tagged frames.
Default Setting
All frame types
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• If a port is is connected to a VLAN-aware device at the other end of
a VLAN trunk, you can set the port to pass only tagged frames.
Otherwise, you must configure the port to pass all frame types.
Example
The following example shows how to restrict the traffic passed on
port 1 to tagged frames:
Related Commands
switchport mode
switchport ingress-filtering
Use this command to enable ingress filtering for an interface. Use the no
form to restore the default.
Syntax
switchport ingress-filtering
no switchport ingress-filtering
Console(config)#interface ethernet 1/1
Console(config-if)#switchport acceptable-frame-types tagged
Console(config-if)#