![background image](http://html1.mh-extra.com/html/smc-networks/7500a-vcp-annexe-1/7500a-vcp-annexe-1_management-manual_1299753280.webp)
C
OMMAND
L
INE
I
NTERFACE
3-144
Example
The following shows information on Trunk 1.
lacp
Use this command to enable 802.3ad Link Aggregation Control Protocol
(LACP) for the current interface. Use the
no
form to disable it.
Syntax
lacp
no lacp
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Command Usage
• Finish configuring a port trunk before you connect the corresponding
network cables between switches.
• You can configure one trunk group, containing up to four ports as a
dynamic LACP trunk.
• The ports on both ends of a trunk must be configured the same for
speed, duplex mode, and flow control.
• If the target switch has also enabled LACP on the connected ports, the
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port type: 100TX-efm
Mac address: 00-30-F1-4D-1E-8B
Configuration:
Name:
Port admin: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full,
Flow control: Disabled
Current status:
Created by: User
Link status: Down
Operation speed-duplex: 100full
Flow control type: None
Member Ports: Eth1/11, Eth1/12,
Console#
Summary of Contents for 7500A/VCP - annexe 1
