![background image](http://html1.mh-extra.com/html/smc-networks/6724al2/6724al2_management-manual_1300175252.webp)
C
OMMAND
L
INE
I
NTERFACE
3-64
notifications are sent. In order to configure the switch to send SNMP
notifications, you must enter at least one
snmp-server host
command. In order to enable multiple hosts, you must issue a separate
snmp-server host
command for each host.
• The
snmp-server host
command is used in conjunction with the
snmp-server enable traps
command. Use the
snmp-server
enable traps
command to specify which SNMP notifications are
sent globally. For a host to receive notifications, at least one
snmp-server enable traps
command and the
snmp-server
host
command for that host must be enabled.
• The switch can send SNMP version 1 or version 2c traps to a host IP
address, depending on the SNMP version that the management station
supports. If the
snmp-server host
command does not specify the
SNMP version, the default is to send SNMP version 1 traps.
• However, some notification types cannot be controlled with the
snmp-server enable traps
command. For example, some
notification types are always enabled.
Example
Related Commands
snmp-server enable traps (3-66)
snmp-server enable traps
Use this command to enable this device to send Simple Network
Management Protocol traps (SNMP notifications). Use the
no
form to
disable SNMP notifications.
Syntax
snmp-server enable traps
[
authentication
|
link-up-down
]
no snmp-server enable traps
[
authentication
|
link-up-down
]
•
authentication
- Keyword to issue authentication failure traps.
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#
Summary of Contents for 6724AL2
