![background image](http://html1.mh-extra.com/html/smc-networks/6724al2/6724al2_management-manual_1300175023.webp)
B
ASIC
C
ONFIGURATION
1-7
Manual Configuration
You can manually assign an IP address to the switch. You may also need to
specify a default gateway that resides between this device and management
stations that exist on another network segment.
Valid IP addresses consist of four decimal numbers, 0 to 255, separated by
periods. Anything outside this format will not be accepted by the CLI
program.
Note:
The IP address for this switch is assigned via DHCP by default.
Before you can assign an IP address to the switch, you must obtain the
following information from your network administrator:
•
IP address for the switch
•
Default gateway for the network
•
Network mask for this network
To assign an IP address to the switch, complete the following steps:
1. From the Privileged Exec level global configuration mode prompt,
type “interface vlan 1” to access the interface-configuration mode.
Press <Enter>.
2. Type “ip address
ip-address netmask
,” where “ip-address” is the switch
IP address and “netmask” is the network mask for the network. Press
<Enter>.
3. Type “exit” to return to the global configuration mode prompt. Press
<Enter>.
4. To set the IP address of the default gateway for the network to which
the switch belongs, type “ip default-gateway
gateway
,” where “gateway”
is the IP address of the default gateway. Press <Enter>.
Summary of Contents for 6724AL2
