SMC Networks 6724AL2, Management Manual

Page: 253 / 424

SNMP C
OMMANDS
3-65
•
link-up-down
- Keyword to issue link-up or link-down traps.
The link-up-down trap can only be enabled/disabled via the CLI.
Default Setting
Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Command Usage
• If you do not enter an
snmp-server enable traps
command, no
notifications controlled by this command are sent. In order to
configure this device to send SNMP notifications, you must enter at
least one
snmp-server enable traps
command. If you enter the
command with no keywords, both authentication and link-up-down
notifications are enabled. If you enter the command with a keyword,
only the notification type related to that keyword is enabled.
• The
snmp-server enable traps
command is used in conjunction
with the
snmp-server host
command. Use the
snmp-server
host
command to specify which host or hosts receive SNMP
notifications. In order to send notifications, you must configure at least
one
snmp-server host
command.
Example
Related Commands
snmp-server host (3-64)
show snmp
Use this command to check the status of SNMP communications.
Default Setting
None
Console(config)#snmp-server enable traps link-up-down
Console(config)#