Ski-Doo FORMULA III, Shop Manual

Page: 324 / 356

Section 09 BODY / FRAME
Sub-Section 01 (BODY)
09-01-3
BELT GUARD
Disassembly and Assembly
NOTE : For additional information (ex. : ex-
ploded view) refer to the correspondent
parts catalog.
WARNING : Engine should be running
only with belt guard and / or pulley guard
well secured in place.
Inspection
All Models
Check belt guard and / or pulley guard mounting
bosses, clips and retainers for wear.
WIRING HARNESS
WARNING : Ensure all terminals are prop-
erly crimped on the wires and that all con-
nector housings are properly fastened. Keep
wires away from any rotating, moving, heating
and vibrating parts. Use proper fastening de-
vices as required.
CABLES
WARNING : Before installation, ensure
that all cables are in perfect condition.
Properly install the cable ends and secure
them in place. Pay attention to route them
properly, away from any rotating, moving,
heating, or vibrating parts.
PIPING
WARNING : Always ensure that the fuel,
vent, primer, impulse, injection oil and ro-
tary valve oil lines are properly fixed to their
connectors, that they are not perforated or
kinked and that they are properly routed away
from any rotating, moving, heating or vibrat-
ing parts. Also check for leaks. Replace if re-
quired.
NOTE : Refer to proper Parts Catalog to find
suitable clip part numbers.
'
;
;
;
;
'