Ski-Doo FORMULA III, Shop Manual

Page: 221 / 356

Section 06 ELECTRICAL
Sub-Section 01 (WIRING DIAGRAMS)
06-01-3
Connector Location
Connectors on wiring diagrams carry the letter C
followed by a number. Use this code with wiring
diagram legend to find connector location on vehi-
cle.
UNPLUGING CONNECTORS
Always unplug connectors by pulling on housing
not on wire. This is particularly important with
connectors on temperature sender and heating el-
ement switches.
TAB AND RECEPTACLE
CONNECTORS REMOVAL
Tab Connector
It is locked in its housing by a spring tab on its
side. Removal is done by squeezing this tab.
1. Locking tab
To remove :
– Insert a screwdriver or Snap-on TT 600-5 from
side opposite of wire and pry locking tab.
– While holding locking tab pryed, pull connector
toward wire side.
Step : Insert screwdriver here
Step : Pull this side
Receptacle Connector
It is locked in its housing by a small tab on top.
Removal is done by squeezing this tab.
1. Locking tab
To remove :
– insert a small screwdriver or Snap-on TT 600-5
in access opening, opposite of wire side, be-
tween receptacle and its housing and squeeze
locking tab.
– While holding locking tab squeezed, pull con-
nector toward wire side.
A06E1PA
A00E1DA
1
A00E1EA
2
1
1
2
A00E1BA
1