Ski-Doo FORMULA III, Shop Manual

Page: 323 / 356

Section 09 BODY / FRAME
Sub-Section 01 (BODY)
09-01-2
DECAL
To remove a decal ; heat old decal with a heat gun
and peel off slowly.
Using isopropyl alcohol, clean the surface and dry
thoroughly.
Apply liquid soap to new decal and carefully posi-
tion the decal. Using a sponge or a squeegee, re-
move the air bubbles and surplus water working
from the center toward the edges. Allow to air
dry.
CAUTION : Do not apply isopropyl alco-
hol or solvant directly on decals.
WINDSHIELD INSTALLATION
When peeling off the protective film some poly-
ethylene particles may remain on the windshield.
A soft clean cloth moistened with naphtha (camp-
ing equipment fuel) will easily remove the remain-
ing particles.
WARNING : Naphtha is flammable and
explosive under certain conditions. Al-
ways manipulate in a well ventilated area. Do
not smoke or allow open flames or sparks in
the vicinity.
Position the windshield on the hood then push it
down until the tabs are fully inserted into the hood
slots. Lock the windshield tabs in position using
latches as shown.
S SERIES
1. Latch
2. Temporary remove headlamp molding for windshield installation
HOOD
S Series
Working from within engine compartment, re-
move exterior nuts retaining both hinges. Then,
close hood and remove interior nuts through the
access holes.
1. Access hole
At installation, loosely install nuts, close hood
then adjust before tightening interior nuts through
access holes.
F Series
Unfasten speedometer cable, wiring harnesses
then retaining cables.
Unbolt front molding and unclip it.
Close hood.
Remove molding.
Remove hinge pin.
At installation, half close hood to install front
molding.
-
;
2
A03H17A
1
A03H14A
1
A06H1NA
1
2