Section 06
ELECTRICAL
Sub-Section 06
(TESTING PROCEDURE)
06-06-9
DUCATI CDI SYSTEM TESTING
(Applicable to 503 Engine Type)
NOTE :
Ensure ignition cut-out switches are
properly working and they are in the ON po-
sition prior to performing the following tests.
WARNING : To prevent powerful electric
shocks while cranking engine, do not
touch neither electronic ignition components
(ignition coil, high tension wire, wire harness,
etc.) nor tester leads.
TRIGGER COIL OUTPUT
1. Disconnect the connector of RED wire at igni-
tion module.
2. Connect tester wires then set switch and dial
as follows :
3. Crank engine and observe indicator.
4. Push reset button and repeat step 3 twice.
Results :
a.
Indicator lamp lights :
Trigger coil output is
up to specifications.
b.
Indicator lamp does not light :
The prob-
lem is a faulty trigger coil or bad grounding.
MAGNETO OUTPUT
(Ignition Generator Coil)
1. Disconnect the 2-wire connector between igni-
tion module and magneto harness.
2. Connect tester wires then set switch and dial
as follows :
3. Crank engine and observe indicator.
4. Push reset button and repeat step 3 twice.
Results :
a.
Indicator lamp lights :
Ignition generator
coil output up to specifications.
b.
Indicator lamp does not light :
The prob-
lem is a faulty ignition generator.
IGNITION COIL OUTPUT
A paper clip of approximately 20 mm (3/4 in) will
be used as a test adapter for the following test.
1. Clip the test adapter around spark plug cable
close to MAG side spark plug.
Tester
wires
Component
wires
Tester
switch
position
Tester
dial
position
N
WHITE / RED
wire of
trigger coil
LOW
45
P
Engine ground
'
;
N
A17E0UA
1
2
Tester
wires
Component
wires
Tester
switch
position
Tester
dial
position
N
GREEN
wire of
magneto harness
LOW
80
P
WHITE
wire of
magneto harness
A17E0VA
1
2
N
Summary of Contents for FORMULA III
