Ski-Doo FORMULA III, Shop Manual

Page: 183 / 356

Section 05 TRANSMISSION
Sub-Section 02 (DRIVE PULLEY)
05-02-6
TOOL REMOVAL
CAUTION : Do not install sliding half on a
vise to remove remaining tool.
Spring Cover Bushing Replacement
Under normal use there is no need to replace this
bushing.
Use tools (P / N 529 0313 00 and 529 0312 00) to
remove old bushing.
CAUTION : Bushing must be bonded with
re-taining compound.
Apply retaining compound outside of bushing
then press it down to counterbore from sliding
half side. Use spring compressor (P / N 529 0151
00) and appropriate flare tools.
CAUTION : Insert bushing from sliding
half side (inner) of spring cover.
Start driving bushing into spring cover.
1. Note upper tool side
Press bushing.
1. Note upper tool side.
ASSEMBLY
NOTE : This drive pulley is lubrication free.
Do not lubricate any component.
1,2,3, Screw, Ring Gear and Loctite 271
Apply Loctite 271 (P / N 413 7029 00) on threads
and under head then torque to 15 N•m (33 lbf•
in ).
26,27,28, Calibration Screw, Washer
and Locking Nut
When installing calibration screw, make sure to in-
stall washer as shown.
A01B41A
420 8765 12
-
A01D2MA
529 0313 00
529 0312 00
-
-
A01D2NA
529 0313 00
529 0312 00
1
A01D2OA
529 0313 00
529 0312 00
1
'