Ski-Doo FORMULA III, Shop Manual

Page: 299 / 356

Section 07 REAR SUSPENSION
Sub-Section 05 (TRACK)
07-05-3
To correct, stop engine then tighten the adjuster
bolt on side where guides are farthest to slide. Re-
check alignment.
1. Guides
2. Slider shoes
3. Tighten on this side
NOTE : Torque retaining screw to 48 N•m
(35 lbf•ft) after adjustment.
Tighten the idler wheel retaining screws.
TYPICAL
1. Retighten
Restart engine, rotate track slowly and recheck
alignment.
TRACK CLEAT
Removal
– Raise rear of vehicle off the ground and lift
snowguard then rotate track to expose a cleat
to be replaced.
– Using track cleat remover (P / N 529 0087 00)
for all models.
Installation
NOTE : Keep the same pitch between guide
cleats.
– Place new cleat in position and using small
track cleat installer (P / N 529 0085 00) bend
cleat then push tabs into rubber.
TYPICAL
1. First step
2. Second step (to push tabs into rubber)
A01F0BA
1
2
3
'
A19F05B
1
'
A01B4UA
1
2