Ski-Doo FORMULA III, Shop Manual

Page: 180 / 356

Section 05 TRANSMISSION
Sub-Section 02 (DRIVE PULLEY)
05-02-3
DISASSEMBLY
1,2, Screw and Ring Gear
CAUTION : Retaining screws must be
heated before disassembly.
5,6, Fixed and Sliding Half
CAUTION : Do not tap on governor cup.
Screw puller into fixed half shaft about 13 mm (1/
2 in). Raise drive pulley and hold it by the sliding
half while knocking on puller head to disengage
fixed half.
1. Puller
2. Holding sliding half
NOTE : No components marking is required
before disassembling this drive pulley since
it has factory mark and arrows as indexing refer-
ence.
25,29, Slider Shoe and Governor Cup
Carefully lift governor cup until slider shoes come
at their highest position into guides.
Hold a slider shoe set then carefully lift its housing
and remove them. Proceed the same way for oth-
er housings lifting one at a time.
32, Cushion Drive
CAUTION : Do not disassemble cushion
drive. Governor cup and cushion drive are
factory balanced as an assembly.
1. Hold slider shoes
2. Lift one housing at a time
NOTE : To ease disassembly, forks (P / N
529 0055 00) should be used to hold slider
shoes prior to removing governor cup.
19, Spring Cover Ass’y
It is pushed by clutch spring pressure.
WARNING : Clutch spring is very strong.
Never attempt to remove spring cover
without the recommended tools.
Use spring compressor (P / N 529 0151 00).
-
-
A16D01A
1
2
'
-
A16D02A
1
2
'
A16B02A
529 0055 00
;