Ski-Doo FORMULA III, Shop Manual

Page: 222 / 356

Section 06 ELECTRICAL
Sub-Section 01 (WIRING DIAGRAMS)
06-01-4
Step : Insert screwdriver here
Step : Pull this side
Locking Receptacle Connector
To remove :
– Insert Snap-on tool TT 600-5 in access opening
then pull housing.
TAB AND RECEPTACLE
CONNECTORS INSTALLATION
Prior to installing, make sure locking tab is suffi-
ciently lifted to properly lock.
Insert tab and receptacle connectors in their re-
spective housings as shown in following illustra-
tions. Push sufficiently so that they snap. Try
pulling wire to ensure they are properly locked.
1. Tab
2. Housing
1. Receptacle
2. Housing
ACCESSORIES INSTALLATION
On all electric start models : The direct current
(DC) utilizes the snowmobile frame as ground
“wire” while all alternating current (AC) consum-
ers (lights, heated grips, fuel gauge, etc.) utilize a
separate ground wire.
Never interconnect AC and DC grounds as an AC
voltage drop will result. When installing accesso-
ries on
any snowmobile, connect their wires di-
rectly to the YELLOW and YELLOW / BLACK
lighting coil wires.
Even if manual start models have an AC ground
to the chassis (on voltage regulator), all accesso-
ries utilize a ground wire isolated from chassis.
When an electric starter kit is installed, the volt-
age regulator and its ground wire are replaced by
a voltage rectifier / regulator unit permitting a
completely isolated AC circuit.
A00E1CA
2
1
1
2
A06E1QA
A00E1GA
1
2
A00E1FA
1
2