Siemens ULTRAMAT 23, Manual, Page: 99 / 244

Operation
7.4 Operating modes
ULTRAMAT 23
Manual, 3/2016, A5E37100388-003
99
The analyzer is in measuring mode (see section Measuring
mode (Page 96)).
Change from measuring mode to input mode by pressing the
<ENTER> key.
You first access the main menu. A cursor flashes on the charac-
ter "A" at the left edge of the first line.
•
You can set the cursor to the start of each line using the < ↑ >
and < ↓ > keys. Cursor movements are cyclic, i.e. if you move
above the top edge of the display, the cursor appears again
in the bottom line, and vice versa.
• Call the respective menu item by pressing the <ENTER>
key.
The cursor is located at "P" when you have pressed the < ↓ >
key twice.
Now call the "Parameters" submenu by pressing the<ENTER>
key.
The adjacent display appears in which you will be requested to
enter the code number for code level 1.
•
You can change the value of the code digit to which the
cursor is pointing using the < ↑ > and < ↓ > keys.
• Move to the next position of the code number using the < → >
key.
This function is also cyclic, and the cursor appears at the
first position again when you move it beyond the last
position.
•
Close the code input by pressing the < ENTER> key.
The initial display of the "Parameters" submenu appears.
Press the <ENTER> again to call the "Measuring ranges" sub-
menu.