Siemens ULTRAMAT 23, Manual, Page: 142 / 244

Functions
8.4 Configuration
ULTRAMAT 23
142
Manual, 3/2016, A5E37100388-003
The functions are shown in the following table:
Table 8- 5 Overview of binary inputs
Function Control with Effect
0 V 24 V
- (vacant)
External fault 1 ... 7 x e.g. signaling of a fault in gas conditioning (cooler, flow, condensation trap,
...)
External maintenance
request 1 ... 7
x e.g. signaling of a maintenance request in gas conditioning (filter, flow, ...)
Function control 1 ... 4 x e.g. signaling of maintenance
Measuring range 1,2 x The corresponding range is selected (autoranging OFF)
Autorange x Autoranging is switched on
Delete logbook x Delete all fault and maintenance request entries
8.4.1.4 Configuration: Inputs/outputs/pump: Pump at CAL/MEAS
You can use this menu to define the response of the pump.
The following parameters and values are possible:
•
Pump at CAL:
Pump switched ON or OFF during an AUTOCAL
•
Pump at MEAS:
Pump switched ON or OFF during measuring mode.
8.4.2 Configuration: Special functions
Following selection of the special functions, the adjacent menu
is displayed with the following options:
•
Change codes
•
Change language
•
Setting of AUTOCAL tolerances
•
Parameterization of interfaces
•
Change physical units in which the measured values are
output
•
Changing the factory settings