Configuration / project engineering
5.6 Configuration with Web Based Management
SCALANCE W786-xPRO
Operating Instructions, Release 08/2007, C79000-G8976-C221-02
145
"Enable (R)STP" check box
Enable this check box, if you want the port to use the (rapid) spanning tree protocol.
●
Priority input box
Enter a value here for the port priority between 0 and 240.
●
"Admin Path Cost" input box
Here, you can enter a value for the STP or RSTP Path Cost parameter. The relevant
value is then used depending on the selected version.
If you enter a zero for the RSTP value, the value for the path costs is calculated
automatically.
●
"Admin Edge Port" check box
Enable this check box if an end device is connected to this port, otherwise a
reconfiguration of the network will be triggered by every link change.
●
"Admin Point to Point Status" drop-down list box
There are three possible settings:
–
Shared media Connection is selected:
This corresponds to "ForceFalse" in the port table.
–
Point to Point Connection is selected:
This corresponds to "ForceTrue" in the port table.
–
Point to Point Connection and Shared Media Connection are selected:
This corresponds to "Auto" in the port table.
