![background image](http://html1.mh-extra.com/html/sick/safers3/safers3_operating-instructions-manual_1264565073.webp)
7.2.11
Save and print the configuration
1. In the application, click
APPLY CHANGES
: the sensors will save the inclination set
and the surrounding environment. The application will transfer the configuration to
the control, and once transfer is complete it will generate a configuration report.
2. Click
to save and print the report.
3. Ask the authorized person for a signature.
7.2.12
Set the control Ethernet parameters
1. Ensure the control is turned on.
2. Press the Network parameter reset button and hold it down during steps 3 and 4.
3. Wait for five seconds.
4. Wait until all the six LEDs on the control turns steady green: the Ethernet parameters
are set to their default values (see
Ethernet connection (if available) on page 97
).
5. Configure the control again.
7.3
Validate the safety functions
7.3.1
Validation
Once the system has been installed and configured, check that the safety functions are
activated/deactivated as expected and that the dangerous area is monitored by the
system.
WARNING
The safeRS3 Designer application facilitates installation and configuration of the
system, but the validation process described below is still required.
7.3.2
Validate the access detection function
Example 1
Starting
conditions
l
Protective field dependency:
Dependent mode
l
All the safety outputs activated
Validation
procedure
1. Access the first protective field .
2. Check that the system deactivates the safety output related to this
protective field and to the following fields (see
).
3. Move inside the area and check that the target position moves in the
safeRS3 Designer app.
4. Repeat step 1 and 3 for each protective field .
5. If the safety outputs are not deactivated (see
).
Specifications
l
Access from several points with particular attention to the side areas of
the field of view and the limit areas (e.g. intersection with any side
guards) (see
Example of access points on the next page
).
l
Access standing as well as crawling.
l
Access moving slowly and quickly.
7 INSTALLATION AND USE PROCEDURES
8027489/2022-03-01 | SICK
Subject to change without notice
O P E R A T I N G I N S T R U C T I O N S | safeRS3
73