![background image](http://html1.mh-extra.com/html/sick/safers3/safers3_operating-instructions-manual_1264565078.webp)
78
O P E R A T I N G I N S T R U C T I O N S | safeRS3
8027489/2022-03-01 | SICK
Subject to change without notice
7 INSTALLATION AND USE PROCEDURES
7.5.3
Locate the area with detected motion
Click
Validation
: the area with detected motion turns red. The detection position
appears on the left.
7.5.4
Restore factory default settings
In
Settings
>
General
click
FACTORY RESET
: the configuration parameters are restored
to the default settings and the admin password is reset.
WARNING
The factory configuration is not a valid configuration. Therefore, the system goes into an
alarm status. The configuration must be validated, and if necessary modified, through
the safeRS3 Designer application by clicking
APPLY CHANGES
.
For the default values of the parameters, see
7.5.5
Identify a sensor
In
Settings
>
Node ID Assignment
or
Configuration
, click
Identify
near the desired
sensor Node ID: the LED on the sensor flashes for 5 seconds.
7.5.6
Change network parameters
In
Settings
>
Network Parameters
change the IP address, the netmask and the
gateway of the control as desired.
7.5.7
Change Modbus parameters
In
Settings
>
Modbus Parameters
enable/disable the Modbus communication and
modify the listening port.
7.5.8
Change Fieldbus parameters
In
Settings
>
Fieldbus Parameters
change the F-addresses and the Fieldbus
Endianness of the control.